Back to Federal guidance

Radiation controls for digital dental radiography

Summary A dental hygienist asked whether lower-dose digital dental X-rays justified fewer safety precautions. OSHA agreed that digital systems reduce exposure but said employers must continue engineering, work-practice, administrative and protective controls as needed to keep exposure as low as reasonably achievable. The ionizing radiation standard still applies.
Document
Federal opinion letter
Agency
Occupational Safety and Health Administration (OSHA)
Document number
2009-04-03-0
Date issued
April 3, 2009
Status
Active
Status last verified October 8, 2026

Apply this to your situation

This page explains the general guidance. Ask about your specific situation and see what current federal labor law says, with citations.

About this page: The full text below is the official document from Occupational Safety and Health Administration (OSHA). Ezel adds the plain-English summary and tracks the document's status. The official source linked on this page is authoritative for any reliance.

April 3, 2009

Lynne H. Slim

[Recipient address omitted]

Dear Ms. Slim:

Thank you for your letter, February 28, 2009, to the Occupational Safety and Health Administration (OSHA). Your letter was forwarded to OSHA's Directorate of Enforcement Programs for a response. As a dental hygienist, you said that you are concerned that there are no guidelines on the radiation hazards when taking digital dental radiographs. You also said that some dental professionals using digital radiography equipment are taking fewer safety precautions because they think very little radiation is emitted from the x-ray tube.

Generally, digital radiography does significantly reduce the amounts of ionizing radiation to which employees or patients may be exposed during diagnostic testing. This advance in technology is an example of an improved engineering control that OSHA advocates. Digital radiography has been developed for dentistry and many other applications, and reduced radiation is only one of the many advantages it provides over conventional (analog) radiography. However, OSHA agrees with you that employers should continue to use additional engineering and work practice controls, administrative controls, and protective equipment, as necessary to maintain radiation exposures as low as reasonably achievable (ALARA), which is the widely-recognized goal for all radiation protection programs. For OSHA compliance, employers using digital radiography systems must also continue to comply with the OSHA standard on ionizing radiation, 29 CFR 1910.1096. If you have a specific complaint about your workplace, you may contact our area office nearest you:

Atlanta West OSHA Area Office

2400 Herodian Way, Suite 250

Smyrna, GA 30080

Ph: 770-984-8700, Fax: 770-984-9031

We thank you for your interest in occupational safety and health. We hope you find this information helpful. If you have any further questions, you can consult OSHA's website at http://www.osha.gov, or you may contact the OSHA Office of Health Enforcement at (202) 693-2190.

Sincerely,

Richard E. Fairfax, Director

Directorate of Enforcement Programs

cc: Atlanta Regional Office

What does federal law require in your situation?

Ezel checks current federal labor law against your facts and answers with citations.

Opens in Ezel Pro.

  • Checks the law as it stands today, not only this page
  • Cites every source it relies on, so you can verify it
  • Chat, drafting and research in one workspace